The Ohlins HO236 STX 36 twin rear shock set is built for the Honda CB 400 Superfour, focusing on controlled damping and consistent chassis behaviour. Designed as a twin-shock rear arrangement, it suits riders who want a more precise and supported feel than typical stock suspension. It is a gas-pressurised design intended to maintain damping consistency as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a clear focus on damping control, feedback and repeatability. This STX-series twin-shock setup is designed to help the rear end stay composed through braking, cornering and acceleration.

Who this shock is for

Suited to road riders looking for improved stability and traction, as well as riders who regularly push harder on spirited rides. It’s also a sensible choice if you’re refreshing an older twin-shock platform and want modern damping behaviour without changing the character of the bike.

Shock design & features

  • Twin rear shock configuration for Honda CB 400 Superfour fitment
  • Gas-pressurised damping system to help reduce fade and maintain consistency
  • STX 36 Twin product family architecture

Tuning controls

This model provides adjustable damping to let you tailor the feel to your tyres, load and riding conditions. It features independent compression and rebound damping adjustment, allowing changes to support and ride comfort without swapping components.

Before you install

Check overall condition of swingarm bushes, linkage and mounting hardware before fitting, as wear in these areas can mask the benefit of a new shock. After installation, confirm sag and damping settings to suit your weight and typical riding load.

Serviceability/lifecycle

As with all performance dampers, periodic servicing helps keep damping consistent and internal wear under control. A regular service schedule is recommended, particularly if the bike sees frequent hard use or challenging road conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO236
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 330.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Stroke Metal to Metal (mm) 88.0
Product Family STX 36 Twin
Fitted Spring 00480-02

More From This Category