The Ohlins TTX30 shock absorber pair is designed for professional Crosskart and Crosskart Xtreme use where consistent damping behaviour and a broad tuning range are required. Built around Ohlins TTX twin-tube architecture, it maintains controlled pressure balance to support predictable performance over changing track conditions. Supplied as a matched pair, with spring installation hardware included.

Ohlins | Made to race, perfected to ride

Developed for competitive environments, this unit is intended for applications where correct fitment, spring choice and setup are handled as part of the overall chassis package. Springs and end eyes are ordered separately, allowing the build to be configured for the specific car and mounting requirements.

Who this shock is for

  • Professional Crosskart and Crosskart Xtreme competition applications
  • Builders and teams needing a serviceable damper with a wide tuning window
  • Installations where spring rate and mounting hardware are selected to suit the chassis

Shock design & features

  • Ohlins TTX twin-tube damping architecture for stable damping behaviour
  • Oil and gas pressure management designed to maintain consistent response under demanding use
  • Fully serviceable construction for ongoing maintenance and rebuild support

Tuning controls

Compression and rebound damping are adjusted separately, enabling changes to support and impact control without forcing a single compromise setting. This makes it suitable for methodical tuning across grip level, surface roughness and driver preference.

Before you install

  • Confirm chassis compatibility and mounting requirements for the intended Crosskart platform
  • Springs are ordered separately; select rates to suit vehicle mass and intended use
  • End eyes are ordered separately; ensure correct fitment for the chosen mounting style
  • Supplied as a pair (two shock absorbers per part number)

Serviceability/lifecycle

This Ohlins unit is designed to be serviced. Regular inspection and scheduled maintenance based on usage conditions help preserve damping consistency and component life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU AT073
Barcode # AT073
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category