The Ohlins TTX RT rear shock absorber for the Suzuki GSX-R 1000 is built around race-derived damping control to help deliver consistent chassis behaviour and tyre contact. Its gas-pressurised, oil/gas separated design is intended to reduce fade during demanding use. Independent compression and rebound circuits are used to keep damping responses clear and repeatable across changing conditions.

Ohlins | Made to race, perfected to ride

TTX RT is a track-focused rear shock platform engineered for accurate damping control and predictable feedback. The layout is aimed at maintaining stability under braking and supporting drive on corner exit.

Shock design & features

  • Gas-pressurised, oil/gas separated architecture to support consistent damping behaviour
  • TTX RT design developed from race technology for controlled suspension movement
  • Intended to improve chassis feedback through fast transient response

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Who this shock is for

Suited to GSX-R 1000 riders prioritising repeatable damping and stability during hard braking, fast direction changes, and aggressive cornering. A good match for riders who want separate compression and rebound control for structured setup changes.

Before you install

  • Confirm compatibility with your exact GSX-R 1000 model and any linkage or ride-height requirements before fitting
  • Inspect bearings/bushes and mounting hardware condition during installation
  • Plan a baseline setup check after fitment to ensure sag and damping are aligned with your use

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU788P
Model # T36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 315.0 +2/-2
Spring Rate Standard 105.0 N/mm
Type Code T36PR1C1LB
Stroke Metal to Metal (mm) 63.0
Product Family TTX RT
Fitted Spring 21040-36

More From This Category