The Ohlins STX 36 Supersport rear shock for the Honda CBR250R is built to deliver controlled damping and clearer chassis feedback on the road and track. Its gas-pressurised design helps maintain consistency as temperatures rise. Designed as a direct-fit rear mono shock, it supports more accurate tuning than a standard unit.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, the STX 36 Supersport range is aimed at riders who want predictable grip and stability with a more tunable suspension package.

Who this shock is for

  • Honda CBR250R riders chasing improved rear-end control and stability
  • Track day riders wanting dependable damping feel over longer sessions
  • Road riders who value clearer feedback and adjustability for load and conditions

Shock design & features

This is a gas-pressurised shock absorber intended to reduce fade and maintain damping consistency. It is supplied as a rear mono shock replacement and forms part of the Ohlins STX 36 Supersport product family.

Tuning controls

The shock provides external rebound damping adjustment and spring preload adjustment, allowing you to set ride height attitude and how quickly the shock returns after compression.

Before you install

  • Set sag and preload for your weight and typical riding load before fine-tuning damping.
  • Inspect linkage bearings and mounting hardware condition during installation.
  • After fitting, re-check all fasteners and confirm free movement through suspension travel.

Serviceability/lifecycle

Like all performance shocks, periodic servicing helps keep damping consistent over time. If the shock is used frequently on track, more regular inspection and service intervals are recommended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO122
Model # S36D
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 297.0
Spring Rate Standard 90.0 N/mm
Type Code S36D
Stroke Metal to Metal (mm) 54.0
Product Family STX 36 Supersport
Fitted Spring 00281-17
Spring Colour Yellow

More From This Category