The Ohlins STX 46 Supersport rear shock for the Benelli Tornado is built around race-derived damping control with a focus on consistent feel and clear chassis feedback. It uses an oil/gas separated design to help maintain stable damping behaviour under sustained load. Adjustable damping circuits let you tailor the shock to your riding and conditions without changing the core architecture.

Ohlins | Made to race, perfected to ride

STX 46 Supersport shocks are developed from Ohlins circuit experience and refined for fast road and track use. The aim is predictable support on the brakes, controlled attitude through the corner, and dependable drive on exit.

Who this shock is for

Suited to riders chasing improved control and tuning range on a Benelli Tornado, particularly for spirited road riding and track days. It is also a strong choice when you want more consistent damping behaviour than a basic, non-adjustable rear unit.

Shock design & features

  • Oil/gas separated monotube shock architecture for consistent damping performance
  • Ohlins valving approach developed for clear feedback and traction management
  • Supersport-focused layout intended for responsive behaviour through rapid load changes

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm the application for Benelli Tornado and rear mono fitment before scheduling installation
  • Set sag and baseline clicker positions after fitting to match rider weight and tyre choice
  • If your bike has been modified (linkage, ride height changes, non-standard spring), plan on a setup check

Serviceability/lifecycle

This Ohlins unit is fully serviceable and intended to be maintained over time. Regular servicing helps keep damping consistent and protects internal components as oil condition and seals age with use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BE914
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 320.0 +10/-2
Spring Rate Standard 85.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 62.0
Product Family STX 46 Supersport
Fitted Spring 01091-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category