The Ohlins BI822 STX 36 twin shock is a rear suspension unit built for the Bimota YB 9. It is designed to deliver controlled damping and consistent chassis behaviour in road and spirited riding conditions. This unit uses a gas-pressurised damping design to help maintain damping stability as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins road shocks are developed around predictable damping control and durability. The aim is to provide clear feedback and stable support so the bike remains composed through acceleration, braking and direction changes.

Shock design & features

  • STX 36 twin shock rear configuration for the Bimota YB 9
  • Gas-pressurised damping system to support consistent damping behaviour
  • Rear fitment for improved traction and stability through the stroke

Tuning controls

This shock provides external damping adjustment for compression and rebound, allowing you to tailor chassis support and wheel control to your riding style and conditions.

Base setup (factory preset)

Ohlins supplies this unit with a factory baseline intended to suit the standard application. Fine-tuning is typically done after installation to account for rider weight, tyre choice and how the bike is used.

Before you install

  • Confirm compatibility for Bimota YB 9 and rear mounting requirements before fitting.
  • Check surrounding clearances and linkage/bearing condition so the shock can work as intended.
  • After installation, set sag and then refine damping to suit your road conditions.

Serviceability/lifecycle

Like other Ohlins shocks, this unit is designed to be serviced to maintain performance over time. Regular inspection and periodic servicing help keep damping consistent and protect internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BI822
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 303.0 +12/-0
Spring Rate Standard 90.0 N/mm
Stroke Metal to Metal (mm) 60.0
Product Family STX 36 Twin
Fitted Spring 01093-29

More From This Category