The Ohlins TR323 STX 36 twin shock is a rear suspension unit designed for the Triumph Speed Twin. Built around Ohlins road and race development, it focuses on consistent damping control and clear feedback at the rear wheel. This model uses a pressurised, oil/gas separated design to help maintain damping stability through changing conditions.

Ohlins | Made to race, perfected to ride

STX 36 twin shocks are engineered for riders who want a controlled, communicative rear end without sacrificing everyday ride quality. The TR323 is a direct-fit rear twin-shock solution intended to suit the Speed Twin’s chassis and mounting layout.

Who this shock is for

  • Street riders chasing better composure, grip and consistency from the rear suspension
  • Owners who want tuning flexibility to suit load, tyre choice and road conditions
  • Riders looking to replace an existing Ohlins unit (this model replaces TR 923)

Shock design & features

  • STX 36 twin-shock architecture
  • Pressurised damping with oil/gas separation for stable performance
  • Supplied with an Ohlins spring fitted

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm correct fitment for Triumph Speed Twin rear twin-shock applications
  • Set sag and baseline damping after installation to match rider weight and typical load
  • Check clearance around the shocks and any accessories before riding

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and revalved when required. Periodic maintenance helps keep damping consistent and protects internal components over the life of the unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU TR323
Model # S36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 384.0 +8/-2
Spring Rate Standard 16.0 - 26.0 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 102.0
Product Family STX 36 Twin
Notes Replaces TR 923
Fitted Spring 60480-02
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category