The Ohlins ACE rear shock absorber pair for the Honda CB 400 SF is built for riders who want a more controlled, consistent ride from their street suspension. Supplied with black springs, it is intended as a direct replacement option focused on damping quality and chassis stability. This listing is for the pair of rear shocks.

Ohlins | Made to race, perfected to ride

Ohlins street shocks are developed with the same engineering approach used across the brand’s motorsport programs, with an emphasis on predictable damping behaviour and long-term consistency.

Who this shock is for

  • Honda CB 400 SF riders upgrading from ageing or under-damped OEM rear suspension
  • Street riders prioritising stability, comfort, and cleaner tyre contact over rough surfaces
  • Owners who want a matched left/right rear shock set

Shock design & features

This product is a rear shock absorber set designed for street use. The input data does not specify whether the shocks use an emulsion layout or separated oil/gas design, so this cannot be confirmed here.

Tuning controls

Adjustment features are not provided in the input data. As a result, damping and spring-preload adjustability cannot be confirmed from this product row.

Before you install

  • Confirm fitment for your exact Honda CB 400 SF model and year before installation.
  • Check the condition of mounting hardware and bushings, and replace worn components as required.
  • After installation, set sag and verify clearance through full suspension travel.

Serviceability/lifecycle

Service requirements and rebuildability are not stated in the provided data, so maintenance intervals and service options cannot be confirmed here.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO132
Barcode # HO132
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category