The Ohlins BM215 STX 46 Adventure rear shock is built for controlled, consistent suspension behaviour on the BMW R 1150 GS Adventure across mixed surfaces and changing loads. It is designed to improve composure over uneven ground while maintaining stability for long-distance adventure and touring use. This is a rear mono shock suited to riders who want reliable adjustability without overcomplication.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, heat management and repeatable setup changes. The STX Adventure range is intended for real-world riding conditions where grip, stability and rider comfort matter over long days.

Who this shock is for

  • BMW R 1150 GS Adventure riders doing adventure touring on sealed and unsealed roads
  • Riders carrying luggage or regularly riding two-up who want steadier chassis control
  • Anyone wanting a serviceable aftermarket rear shock with external adjustments

Shock design & features

This is an STX 46 rear mono shock with an oil/gas separated internal architecture for consistent damping during sustained use. The design is aimed at keeping damping behaviour stable when conditions change, such as long rough sections or when load and pace vary.

Tuning controls

The BM215 provides external rebound damping adjustment and compression damping adjustment so you can tune how the shock returns after bumps and how it resists compression over impacts and undulations. It also includes spring preload adjustment to suit rider weight and additional load from luggage or a pillion.

Before you install

  • Confirm all mounting hardware and clearances during installation on the rear mono position.
  • Set sag with the correct preload for your typical load, then fine-tune rebound and compression damping from there.
  • If you frequently switch between solo and loaded riding, note your preferred settings so you can return to a known baseline.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained and serviced to keep performance consistent over time. Routine servicing helps refresh oil and seals, and allows inspection of wear items to support long-term reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM215
Model # S46DR1S
Barcode # BM215
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 390.0
Spring Rate Standard 140.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 70.0
Product Family STX 46 Adventure
Notes Rear
Fitted Spring 01095-54
Spring Colour Yellow

More From This Category