The Ohlins BM709 STX 36 Supersport front shock is built for the BMW R 1200 R, focusing on controlled damping and clear front-end feedback. It is designed to support confident braking and cornering by maintaining consistent suspension behaviour. This unit uses an oil/gas separated damping design for stable performance during sustained riding.

Ohlins | Made to race, perfected to ride

Ohlins Supersport suspension is developed from competition-derived design principles, with practical tuning range for road and track-focused riders. The STX 36 architecture is intended to deliver predictable response and repeatable setup changes.

Shock design & features

  • Front mono shock for BMW R 1200 R fitment
  • STX 36 Supersport design with oil/gas separation to help maintain damping consistency
  • Valving developed for strong chassis control and front-end stability

Tuning controls

  • Rebound damping adjustment

Base setup (factory preset)

Supplied with a fitted spring as delivered by Ohlins. The shock is intended to be installed and then fine-tuned via rebound adjustment to suit rider preference, tyres, and typical road conditions.

Before you install

  • Confirm correct model fitment and front mounting position for your BMW R 1200 R
  • Inspect mounting hardware and surrounding components before installation
  • After installation, check sag and handling balance before making damping changes

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM709
Model # S36DR1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 327.0 +8/-2
Spring Rate Standard 57.0 N/mm
Type Code S36DR1L
Stroke Metal to Metal (mm) 73.0
Product Family STX 36 Supersport
Notes Front
Fitted Spring 00180-44
Spring Colour Yellow

More From This Category