The Ohlins STX 46 Supersport rear shock for the Ducati 999 Biposto is built around proven suspension architecture for consistent damping and clear feedback at the tyre. It is a rear mono shock designed to support fast road and track use where stability and traction matter. This unit uses an oil/gas separated design to help maintain damping control as conditions change.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, the STX 46 Supersport range focuses on dependable performance and a wide, usable adjustment window. The aim is predictable behaviour through braking, turn-in and drive, without making setup overly complex.

Who this shock is for

  • Ducati 999 Biposto riders chasing more composed rear-end control than a standard shock can offer
  • Track-day riders who need repeatable damping and the ability to tune for tyres and pace
  • Owners refreshing an ageing rear suspension with a serviceable, performance-oriented unit

Shock design & features

This is an STX 46 Supersport rear mono shock with an oil/gas separated layout. The separation helps reduce aeration under hard use, supporting consistent damping feel. It is built as a serviceable unit, intended to be maintained over its lifecycle rather than treated as disposable.

Tuning controls

This shock provides external damping adjustment for rebound and compression, allowing you to refine chassis behaviour for grip, stability and weight transfer. It also includes a spring preload adjuster to set ride height and support for rider weight and load.

Before you install

  • Confirm fitment for Ducati 999 Biposto and check clearances around the linkage and exhaust
  • Set sag and preload first, then use rebound and compression adjustments to fine-tune response
  • Inspect bearings, linkage and mounting hardware condition during installation

Serviceability/lifecycle

Ohlins shocks are designed to be rebuilt, revalved and serviced as required. Regular servicing helps maintain damping consistency and ensures the adjusters continue to work as intended over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU327
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0
Spring Rate Standard 75.0 N/mm
Type Code S46PR1C1
Stroke Metal to Metal (mm) 71.0
Product Family STX 46 Supersport
Fitted Spring 01091-21
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category