The Ohlins DU118 STX 46 Street rear shock is built for Ducati Hypermotard riders who want clearer chassis feedback and consistent damping on spirited road rides and occasional track use. Developed from Ohlins racing experience, it focuses on control, grip and stability through changing speeds and surfaces. The design uses a gas-pressurised layout to help maintain damping consistency during longer or harder sessions.

Ohlins | Made to race, perfected to ride

Ohlins STX Street shocks are engineered to deliver predictable suspension behaviour and a more composed ride. This unit is intended as a direct-fit rear mono shock solution for the listed Hypermotard models.

Who this shock is for

  • Riders chasing improved rear-end control under braking and corner entry
  • Street-focused riders who want confidence and stability during aggressive riding
  • Owners who want adjustment range to suit different roads, tyres and riding styles

Shock design & features

This shock uses a gas-pressurised, oil/gas separated design to support consistent damping behaviour. Ohlins valving is aimed at improving traction and stability, especially when the bike is loaded up through braking and acceleration.

Tuning controls

Adjustability includes compression damping, rebound damping, and a hydraulic spring preload adjuster. These controls allow you to balance comfort, grip and support without changing core components.

Before you install

  • Set sag and preload first, then fine-tune rebound and compression to suit your roads and pace
  • Confirm clearances and routing around the shock and reservoir hardware during fitment
  • After installation, re-check fasteners and settings after the first rides as the suspension beds in

Serviceability/lifecycle

Like all performance dampers, the DU118 benefits from periodic servicing to keep oil condition and damping behaviour consistent over time. Regular maintenance is especially important if the bike sees frequent hard riding or track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU118
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code S46PR1C1
Stroke Metal to Metal (mm) 71.0
Product Family STX 46 Street
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category