The Ohlins DU931 TTX RT rear shock is built for Ducati 1098, 1198 and 848 riders chasing repeatable damping control and clear feedback. Developed from Ohlins’ twin-tube TTX architecture, it focuses on stability under load and consistent behaviour as conditions change. This unit is a direct-fit rear mono replacement intended for performance street and track use.

Ohlins | Made to race, perfected to ride

The TTX RT family brings race-derived damping principles to a road/track package, with a focus on controlled chassis movement and predictable grip. For Ducati superbike platforms, it is designed to support confident braking, turn-in and drive.

Who this shock is for

  • Riders upgrading the rear of a Ducati 1098, 1198 or 848 for sharper, more consistent suspension response
  • Track day and spirited road riders who want repeatable damping control
  • Owners wanting a purpose-built rear mono shock rather than reworking the stock unit

Shock design & features

This is a pressurised, oil/gas separated twin-tube (TTX) shock, designed to maintain damping consistency through demanding use. Separate damping circuits allow more controlled behaviour across different shaft speeds compared with simpler layouts.

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment

Before you install

Fitment is intended as a rear mono replacement for Ducati 1098, 1198 and 848 models. Professional installation is recommended, followed by setting sag and verifying damping settings suit your tyres, load and riding conditions. Note: this part is marked as MKII and is replaced by DU 531.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU931
Model # T36PR1C1B
Barcode # DU931
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 294.5
Spring Rate Standard 80.0 N/mm
Type Code T36PR1C1B
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Notes MKII *Replaced by DU 531*
Fitted Spring 21040-24
Spring Colour Yellow

More From This Category