The Ohlins SU803 STX 36 Twin rear shock set is built for Suzuki GSX 750 applications that run a twin-shock rear end and need controlled, consistent damping. Based on Ohlins road and race development, it focuses on chassis stability and clear feedback rather than harshness. This is a gas-pressurised design intended to keep damping behaviour stable across changing conditions.

Ohlins | Made to race, perfected to ride

Ohlins engineering is centred on predictable damping control and a balanced feel at the tyre contact patch. The result is suspension you can tune methodically and trust when pace and loads increase.

Shock design & features

  • STX 36 Twin rear configuration suited to twin-shock fitment on the GSX 750.
  • Gas-pressurised damping to support consistent performance during extended riding.
  • Designed to improve rear-wheel control and overall chassis composure.

Tuning controls

This rear shock set provides external damping adjustment for both compression and rebound, allowing you to tailor the response to riding style and road conditions.

Before you install

  • Confirm the bike’s rear suspension layout matches the required rear twin-shock fitment.
  • After installation, set sag and verify damping settings methodically to suit your load and tyres.

Serviceability/lifecycle

Ohlins shocks are designed to be maintained over time. Periodic servicing helps keep damping consistent and preserves seal life and oil condition.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU803
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 320.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Stroke Metal to Metal (mm) 95.0
Product Family STX 36 Twin
Fitted Spring 00480-02

More From This Category