The Ohlins STX 46 Street rear shock is built for riders who want clear damping feedback and a controlled chassis on the road. Developed from Ohlins suspension know-how, it targets improved stability, traction and consistency over a wide range of conditions. This unit is designed as a direct-fit rear mono shock for the Honda CB650F and CBR650F.

Ohlins | Made to race, perfected to ride

STX Street shocks are engineered to bring Ohlins ride quality and adjustability to everyday riding. The focus is on predictable response, grip and stability without making the bike harsh. It is a practical upgrade for riders who value feel and control rather than just firmness.

Who this shock is for

  • Street riders chasing more composure through corners and over rougher surfaces
  • Owners wanting improved traction and stability under braking and acceleration
  • Riders who want external adjusters to tailor the bike to load, tyres and riding style

Shock design & features

This is an STX 46 Street rear mono shock with a gas-pressurised, oil/gas separated design to help maintain consistent damping under heat and repeated use. The architecture is intended to reduce fade and deliver more repeatable behaviour on longer rides.

Tuning controls

Adjustment is provided for rebound damping and compression damping, along with spring preload to suit rider weight and luggage. These controls let you fine-tune support and comfort while keeping the bike settled when conditions change.

Base setup (factory preset)

The shock is supplied with an Ohlins-fitted spring and a baseline setting intended to work as a starting point for road use. Final setup should be tailored to your weight, typical load and how you prefer the bike to respond.

Before you install

  • Confirm compatibility with the Honda CB650F and CBR650F rear mono configuration
  • Inspect linkage and mounting hardware for wear before fitting a new shock
  • After installation, set preload first, then refine rebound and compression to suit your roads

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO713
Model # S46HR1C1
Barcode # HO713
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 331.0
Spring Rate Standard 170.0 N/mm
Type Code S46HR1C1
Stroke Metal to Metal (mm) 49.0
Product Family STX 46 Street
Fitted Spring 60016-69
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category