The Ohlins FCX1302 TTX 22 Fork Cartridge Front is designed to improve front-end control and feedback on select Beta RR 2T and 4T models. It focuses on delivering more consistent damping behaviour under braking and through corner entry. Separate adjustment circuits allow you to tailor the feel to your riding conditions and preferences.

Ohlins | Made to race, perfected to ride

Built around Ohlins cartridge technology, this kit is intended to deliver a more controlled and predictable front-end response. It is a suspension upgrade aimed at riders who want clearer feedback and better stability without compromising durability.

Who this cartridge kit is for

Suited to Beta RR riders chasing improved braking stability, mid-corner feel, and confidence from the front tyre. A good match for riders who want a tunable setup for varied terrain and pace.

Shock design & features

  • TTX 22 fork cartridge system
  • Designed to enhance front-end feedback and braking stability
  • Premium internal components for consistent performance and durability

Tuning controls

  • Separate compression adjustment
  • Separate rebound adjustment

Before you install

This is a front fork cartridge kit designed for Beta RR 2T and 4T models listed for FCX1302 fitment: RR 2T 125, RR 2T 200, RR 2T 250, RR 2T 300, RR 4T 350, RR 4T 390, RR 4T 430, RR 4T 480.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FCX1302
Model # T22DR1C1
Barcode # FCX1302
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code T22DR1C1
Fork Length (mm) 951.0
Stroke Metal to Metal (mm) 295.0
Product Family TTX 22
Notes 08762- spring series *Replaces FCX 0302*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01330-

More From This Category