The Ohlins HO153 is an STX 36 twin rear shock setup for classic Honda models running twin rear suspension. Built around Ohlins street-focused damping design, it’s intended to improve stability, control and ride feel when compared with worn or outdated units. It’s a fitment-specific replacement designed to suit the chassis and linkage-free twin-shock layout.

Ohlins | Made to race, perfected to ride

Ohlins twin shocks are developed from the same engineering approach used across the brand’s racing programs, adapted for real-world road use. The aim is predictable damping behaviour, consistent performance as conditions change, and a clear platform for setup.

Who this shock is for

Suited to riders restoring or upgrading a twin-shock Honda and wanting modern damping control without moving away from the original architecture. It’s also appropriate if you want a more controlled rear end under braking, corner entry and acceleration on road rides.

Shock design & features

This is a gas-pressurised shock design for consistent damping behaviour. As an STX 36 twin-shock package, it’s built as a matched rear pair intended to work together to support the chassis and improve traction and stability.

Tuning controls

Damping is adjustable for rebound and compression, allowing you to tailor response for comfort, support and grip. Spring preload adjustment is provided to set ride height and sag for your load and riding style.

Before you install

  • Confirm your exact model and year match the listed Honda CB and CBX applications before fitting.
  • Check swingarm and mounting hardware condition, and replace worn bushes or fasteners as required.
  • After installation, set preload and damping from a sensible baseline, then fine-tune after a short test ride.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO153
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 364.0
Spring Rate Standard 18.0 - 27.0 N/mm Progressive
Stroke Metal to Metal (mm) 97.0
Product Family STX 36 Twin
Fitted Spring 00480-03

More From This Category