The Ohlins TTX 44 rear shock for the Honda CRF 450R is built around a race-developed damping architecture focused on control and consistency. It uses a pressurised, oil/gas separated design to help maintain stable damping through demanding moto and enduro conditions. Set up correctly, it supports traction and chassis balance when the pace increases.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered for riders who want a more controlled feel and wider tuning range than standard equipment. The TTX platform is designed to deliver predictable damping behaviour and repeatable adjustments. This unit is supplied without a spring, allowing the correct rate to be selected for rider weight and use.

Who this shock is for

  • Honda CRF 450R riders chasing improved rear-end control in motocross or off-road riding
  • Riders who tune suspension for track conditions and want clear, usable adjustments
  • Those replacing a worn or underperforming rear shock with a serviceable performance unit

Shock design & features

  • TTX 44 architecture with an oil/gas separated, pressurised damping system for consistent performance
  • Developed to provide stable chassis behaviour under load changes
  • Spring is not supplied; spring selection is required before installation

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • This shock is supplied with no spring; fit the correct spring before use (see product notes for spring series guidance)
  • After installation, set sag and baseline damping to suit rider weight and conditions
  • Inspect linkage bearings and mounts during fitting to ensure the shock can work as intended

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO1694
Model # T44PR1C2W
Barcode # HO1694
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 479.0
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Product Family TTX 44
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

Related products

More From This Category