The Ohlins KA1893 TTX Flow Shock Rear is built for the Kawasaki KX 250F and developed from Ohlins motocross racing know-how. It’s a rear mono shock designed to deliver controlled damping behaviour and consistent feel across changing track conditions. Supplied without a spring, it’s intended to be matched with the correct spring rate for the rider and application.

Ohlins | Made to race, perfected to ride

Ohlins TTX Flow technology is focused on stable damping performance and clear chassis feedback for motocross and enduro use. The design is intended to help the bike stay settled through braking bumps, jump landings and corner exits while maintaining traction.

Shock design & features

This model uses a gas-pressurised, oil/gas separated shock architecture rather than an emulsion layout. The internal damping arrangement is designed to keep damping response consistent during demanding riding and extended motos.

Tuning controls

The KA1893 provides external adjustment for both compression and rebound damping. This allows you to balance support and comfort to suit track layout, surface condition and riding style, without changing internal components.

Base setup (factory preset)

The shock is delivered with an Ohlins base setting intended as a starting point. With the correct spring fitted, fine-tuning compression and rebound can be used to dial in ride height, grip and stability for your local conditions.

Before you install

No spring is supplied with this unit. Confirm the required spring series and select the appropriate spring separately before installation, then set sag and damping to suit the bike and rider.

Serviceability/lifecycle

As a rebuildable performance shock, periodic servicing is part of maintaining consistent damping and seal life. Regular oil and wear-part replacement helps keep performance repeatable over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA1893
Model # T46PR1C1W
Barcode # KA1893
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 486.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category