The Ohlins TTX 44 rear shock for the Yamaha WR 450F is built around a race-developed damping layout aimed at delivering consistent control and clear feedback through the chassis. It is designed to help the rear tyre stay connected across changing terrain while keeping the bike settled under load changes. This unit uses a separated oil and gas design to maintain damping stability during longer, harder rides.

Ohlins | Made to race, perfected to ride

TTX technology is based on a twin-tube damping concept that supports stable pressure control and repeatable performance. On an enduro platform like the WR 450F, that translates to predictable response when the pace increases and conditions vary.

Who this shock is for

Suited to riders who want a more controlled rear end with the ability to fine-tune the bike for terrain, grip level and rider preference. It is also a good match when you want more consistent damping behaviour across a ride, rather than a setup that changes noticeably as conditions heat up.

Shock design & features

  • Rear mono shock absorber design for off-road use
  • Ohlins TTX architecture for stable, consistent damping character
  • Separated oil and gas arrangement to help maintain damping consistency

Tuning controls

This shock provides external adjustment for rebound damping and compression damping, allowing you to balance traction, support and comfort to suit your riding and terrain.

Before you install

  • Confirm fitment for your exact Yamaha WR 450F model and year prior to installation.
  • This product row indicates no spring is supplied; you will need to select a suitable spring for rider weight and intended use.
  • After installation, set sag correctly before making damping changes.

Serviceability/lifecycle

Like all high-performance off-road shocks, regular servicing is important to keep damping consistent and protect internal components from wear and contamination. Service intervals should be based on hours and riding conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA1484
Model # T44PR1C2W
Barcode # YA1484
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 490.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Stroke Metal to Metal (mm) 120.0
Product Family TTX 44
Notes 06310- series spring
Fitted Spring 00480-02
Spring Colour Black

More From This Category