The Ohlins STX 36 twin rear shock set for the Kawasaki ZRX 1100 is built to deliver consistent damping control and clear chassis feedback for road riding. The design focuses on stability, traction and predictability across changing conditions. It suits riders who want adjustability without compromising durability and service support.

Ohlins | Made to race, perfected to ride

Ohlins twin shocks are engineered with proven internal architecture and quality control to suit performance road bikes. The STX platform is designed to provide controlled movement through the stroke and reliable temperature management in real-world use.

Shock design & features

  • Twin rear shock layout to suit the ZRX 1100’s chassis and mounting arrangement.
  • Oil/gas separated, gas-pressurised damping system for consistent behaviour during longer rides.
  • STX 36 family construction aimed at stable damping response and good rear-tyre contact.

Tuning controls

  • Rebound damping adjustment to control how quickly the rear returns after bumps and load changes.
  • Compression damping adjustment to manage support under braking, corner entry and larger impacts.
  • Spring preload adjustment to set ride height and balance for rider weight and load.

Base setup (factory preset)

This unit is supplied with an Ohlins baseline tune intended to work as a starting point for the ZRX 1100. From there, rebound, compression and preload can be adjusted to match tyres, road surface and rider preference.

Before you install

  • Confirm fitment for Kawasaki ZRX 1100 and check clearance around exhaust, chain line and rear guard at full movement.
  • Inspect linkage and mounting hardware condition so the shocks can work without stiction or play.
  • After installation, set sag and balance front-to-rear before fine-tuning damping.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to maintain performance over time. Regular inspection and periodic servicing help keep damping consistent and protect internal components, especially if the bike is used in wet or harsh conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO417
Model # S36PR1C1L
Barcode # HO417
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 365.0 +8/-2
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 92.0
Product Family STX 36 Twin
Fitted Spring 00480-33
Spring Colour Yellow

More From This Category