The Ohlins TTX Flow rear shock for the Honda CRF 450R is built around a racing-derived damping architecture aimed at delivering stable, repeatable control on track. It uses a separated oil and gas layout to help maintain consistent damping behaviour as conditions change. The shock is intended for riders who want a suspension unit that can be tuned accurately to suit their pace and terrain.

Ohlins | Made to race, perfected to ride

TTX Flow is Ohlins’ twin-tube approach to rear shock design, developed to provide controlled damping response and clear feedback from the rear tyre. The layout is designed to support traction and chassis stability through high-load riding.

Who this shock is for

  • CRF 450R riders wanting a higher level of damping control than a basic replacement shock
  • Riders who tune their suspension for different tracks, surfaces, and riding intensity
  • Owners planning a complete suspension setup (spring selection required)

Shock design & features

  • TTX Flow twin-tube architecture for controlled damping response
  • Separated oil and gas construction (gas pressurised) to support consistency during use
  • Rear mono shock configuration for Honda CRF 450R fitment

Tuning controls

This shock provides external adjustment for rebound damping and compression damping. Independent circuits allow you to tune balance and feel without having to change internal parts for normal setup work.

Before you install

  • No spring is supplied; the correct spring must be selected and purchased separately
  • Spring compatibility is noted as the 06310-series
  • Confirm fitment and spring rate choice before installation to match rider weight and intended use

Serviceability/lifecycle

As a performance rear shock, it is designed to be serviced and revalved as required. Regular inspection and periodic servicing will help maintain damping consistency and component life.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO1794
Model # T46PR1C1W
Barcode # HO1794
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- series spring
Fitted Spring Sold separately, see notes.

Related products

More From This Category