The Ohlins KA364 TTX GP rear shock is built for Kawasaki ZX-10R applications where consistent damping control and clear chassis feedback matter most. Based on Ohlins’ TTX architecture, it uses a separated oil/gas design to help maintain stable behaviour during sustained hard use. It is supplied as a direct-fit rear mono shock for track-focused and performance road setups.

Ohlins | Made to race, perfected to ride

TTX GP products are developed from Ohlins racing programs and tuned to deliver controlled damping and predictable feel. The design focus is on stability under braking, grip on corner exit, and repeatable performance across a session.

Who this shock is for

  • ZX-10R riders who prioritise track performance and accurate rear-end feedback
  • Riders wanting broad tuning range for different tyres, circuits, and riding styles
  • Owners upgrading from stock suspension for improved control under aggressive inputs

Shock design & features

  • Rear mono shock in Ohlins TTX GP family
  • Separated oil/gas, pressurised system for consistent damping behaviour
  • Race-derived valving approach aimed at traction and stability

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment
  • Ride height adjustment for chassis balance changes

Before you install

  • Fitment note: not for 2018 ZX-10R SE (semi-active) version
  • This model has been replaced by KA 468
  • After installation, set sag and damping to suit your weight, tyres, and intended use

Serviceability/lifecycle

As a rebuildable performance shock, regular servicing helps keep damping response consistent and protects internal components. Service intervals depend on track time, conditions, and maintenance practices.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA364
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 309.0 +4/-2
Spring Rate Standard 95.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 57.0
Product Family TTX GP
Notes *Not for 2018 SE (Semi-active) Version* *Replaced by KA 468*
Fitted Spring 21040-31
Spring Colour Yellow

More From This Category