The Ohlins STX 36 Supersport rear shock for the Kawasaki Ninja 400(R) is built to provide controlled damping and consistent chassis feedback under demanding riding. Developed from Ohlins racing know-how, it focuses on stability, traction and predictable response. It’s designed as a rear mono shock replacement for riders who want a more tunable suspension package.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered with a strong focus on damping control and repeatable performance. The STX 36 Supersport family is aimed at sporty road and track use where clear feedback and adjustability matter.

Who this shock is for

Suited to Kawasaki Ninja 400(R) riders chasing improved control during braking, corner entry and drive out. A good match for regular track day use or fast road riding where the standard rear shock can feel under-damped or inconsistent.

Shock design & features

This model uses an STX 36 architecture with a gas-pressurised, oil/gas separated design to help maintain damping consistency as conditions change. It’s designed to improve rear tyre contact and support the chassis through load transitions.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to balance grip and stability to suit tyres, pace and surface conditions. These controls are intended to make setup changes clear and repeatable.

Before you install

Confirm fitment for the Kawasaki Ninja 400(R) and inspect linkage, bearings and mounting hardware condition before installation. After fitting, set sag and baseline damping to suit rider weight and intended use, then fine-tune from there.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA041
Model # S36D
Barcode # KA041
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 284.0
Spring Rate Standard 160.0 N/mm
Type Code S36D
Stroke Metal to Metal (mm) 41.0
Product Family STX 36 Supersport
Fitted Spring 00281-36
Spring Colour Yellow

More From This Category