The Ohlins STX 46 Street rear shock for Kawasaki Ninja 1000SX and Z 1000 SX is designed to improve chassis control and consistency for road riding. Built around Ohlins street-focused valving, it aims to deliver predictable damping and better tyre contact over varying surfaces. This unit is supplied as a replacement rear mono shock to suit the standard mounting arrangement.

Ohlins | Made to race, perfected to ride

Ohlins street suspension draws from the brand’s competition experience, adapted for real-world road speeds and conditions. The focus is control and repeatability rather than harshness, with damping behaviour intended to remain stable as conditions change.

Who this shock is for

Suited to riders who want a more controlled rear end on the road, particularly when braking, accelerating out of corners, or carrying load. It’s a good match for owners chasing clearer feedback and stability from the rear suspension without turning the bike into a track-only setup.

Shock design & features

This is a gas-pressurised design to help maintain damping consistency under sustained use. The STX 46 Street construction is intended to support stable oil control and predictable response through the stroke, improving traction and composure over uneven roads.

Tuning controls

This shock includes external rebound damping adjustment and a spring preload adjustment, allowing you to balance ride comfort, support, and rear-wheel control to suit your weight, tyres, and typical road conditions.

Before you install

  • Confirm the fitment for your exact model and year of Kawasaki Ninja 1000SX / Z 1000 SX before installation.
  • After fitting, set sag and then fine-tune rebound to match your riding conditions.
  • Inspect linkages and bearings during installation to ensure the shock can perform as intended.

Serviceability/lifecycle

Like all performance suspension, periodic servicing helps keep damping consistent and internal components in good condition. Regular maintenance is especially important if the bike is ridden frequently in wet/dirty conditions or with heavy loads.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA110
Model # S46DR1S
Barcode # KA110
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 356.0
Spring Rate Standard 100.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 61.0
Product Family STX 46 Street
Fitted Spring 01091-34
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category