The Ohlins KA1794 TTX Flow rear shock is a motocross rear mono unit designed for Kawasaki KX 250F and KX 450F fitment. Built around Ohlins’ TTX Flow architecture, it aims to deliver consistent damping control and clear feel at the rear tyre. This unit is supplied without a spring, allowing you to match spring rate to rider weight and intended use.

Ohlins | Made to race, perfected to ride

TTX Flow is derived from Ohlins competition development, focusing on controlled damping behaviour through a wide range of operating conditions. The design targets stability under braking and predictability when driving out of corners.

Who this shock is for

Suited to riders chasing improved rear-end control and adjustability for motocross use. It’s also a sensible option if you want the flexibility to select your own spring rather than being locked into a supplied rate.

Shock design & features

This is a gas-pressurised, oil/gas separated rear shock using the TTX Flow layout. Independent damping circuits are used to support traction and chassis stability across changing track conditions.

Tuning controls

The shock includes external adjustment for rebound damping and compression damping, allowing you to tune feel and support to suit track layout, tyre choice and rider preference.

Before you install

  • Rear mono fitment for Kawasaki KX 250F and KX 450F.
  • No spring is supplied; spring is sold separately (see notes for spring series guidance).

Serviceability/lifecycle

Like all performance shocks, regular servicing helps maintain consistent damping and seal life, particularly in muddy or high-hour motocross use. Using the recommended Ohlins oil is part of maintaining intended performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA1794
Model # T46PR1C1W
Barcode # KA1794
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 486.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category