The Ohlins TTX Flow rear shock is a dedicated upgrade for Kawasaki KX 450F applications where consistent damping control and clear feedback matter. Built around Ohlins’ twin-tube approach, it is designed to keep the rear wheel tracking accurately through braking bumps, acceleration chop and mixed track conditions. This unit is supplied without a spring, allowing you to match spring rate to rider weight and use.

Ohlins | Made to race, perfected to ride

TTX Flow technology focuses on stable damping characteristics and predictable behaviour across changing temperatures and track surfaces. The design aims to deliver repeatable feel, helping you set the bike up once and refine from there.

Shock design & features

  • Twin-tube (TTX) architecture with oil and gas separated for consistent damping behaviour
  • Rear mono shock configuration for Kawasaki KX 450F fitment
  • Spring is not supplied; spring selection is made separately (see notes in listing)

Tuning controls

This shock includes external damping adjustment for both compression and rebound, allowing you to balance bump absorption, chassis attitude and traction to suit track conditions and riding style.

Before you install

  • Confirm spring choice before fitment, as this unit is supplied without a spring
  • Set sag and verify linkage and bearings are in good condition to get meaningful results from damping changes
  • After initial ride time, re-check fasteners and settings as the setup settles

Serviceability/lifecycle

Ohlins motocross shocks are designed to be serviced and re-valved. Regular maintenance keeps damping consistent and protects internal components, especially when used in muddy or high-hour conditions.

Is it right for you?

If you want a rear shock with separate compression and rebound adjustment and a twin-tube design aimed at consistent feel over a moto, this TTX Flow unit is a strong match. If you prefer a fit-and-forget solution with a supplied spring, factor in spring selection as part of the setup process.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA1894
Model # T46PR1C1W
Barcode # KA1894
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 486.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.

More From This Category