The Ohlins KA340 TTX GP rear shock is built for the Kawasaki ZX-10R and is aimed at riders chasing predictable damping and clear chassis feedback. It uses Ohlins’ TTX architecture with separated oil and gas to help maintain damping consistency under sustained load. Designed for circuit-focused use, it supports precise adjustment so you can tailor balance and grip to tyre, track and riding style.

Ohlins | Made to race, perfected to ride

  • TTX GP rear mono shock application for Kawasaki ZX-10R
  • Separated oil/gas design to support stable damping behaviour
  • Intended for high-demand track riding where repeatability matters

Who this shock is for

  • Track day riders and racers wanting a wider, more precise tuning window than standard suspension
  • Riders looking to refine rear grip, stability and mid-corner support through adjustment rather than trial-and-error spring swaps
  • Setups where consistent damping feel over a session is a priority

Shock design & features

  • TTX GP design with separated oil and gas for consistent performance
  • Race-derived damping layout aimed at improving control during braking, turn-in and corner exit
  • Rear mono-shock configuration to suit the ZX-10R chassis layout

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Hydraulic spring preload adjustment
  • Ride height (length) adjustment for chassis balance changes

Before you install

  • Confirm your current linkage condition and torque settings during fitment, as wear can mask suspension changes
  • Start from the factory preset and make one change at a time to isolate effects
  • Record baseline settings and ambient/track conditions to keep your tuning process repeatable

Serviceability/lifecycle

  • Serviceable design intended for ongoing maintenance and revalving as requirements change
  • Regular servicing helps maintain damping consistency and internal component life, especially with frequent track use

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA340
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 309.0 +6/-0
Spring Rate Standard 110.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 59.0
Product Family TTX GP
Notes Type TTX GP
Fitted Spring 21040-39

More From This Category