The Ohlins TR729 STX 36 Street rear shock is built to improve control and feedback on the road for the Triumph Bonneville Bobber. It’s a rear mono shock designed to deliver consistent damping behaviour and clearer chassis communication. This unit is configured for straightforward, rider-focused tuning.

Ohlins | Made to race, perfected to ride

Ohlins street shocks draw on proven damping architecture to deliver predictable support through braking, cornering and acceleration. The STX 36 family focuses on stability and feel without making setup unnecessarily complex.

Shock design & features

  • STX 36 rear mono shock layout
  • Oil/gas separated shock design for consistent damping behaviour
  • Supplied with a black spring

Tuning controls

  • Rebound damping adjustment

Base setup (factory preset)

This shock is supplied with an Ohlins baseline setting intended to suit the standard fitment and typical street use. From there, rebound adjustment lets you refine control to match your riding style, load and road conditions.

Before you install

  • Confirm the application matches a Triumph Bonneville Bobber rear mono shock fitment
  • Set sag and check clearances after installation, especially if ride height or spring preload is changed
  • Inspect mounting hardware and bushings during fitment

Serviceability/lifecycle

Like other Ohlins units, periodic servicing helps maintain damping consistency and seal life. Service intervals depend on use conditions and kilometre accumulation.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU TR729
Model # S36DR1
Barcode # TR729
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 270.0
Spring Rate Standard 36.0 N/mm
Type Code S36DR1
Stroke Metal to Metal (mm) 54.0
Product Family STX 36
Fitted Spring 60282-11
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category