The Ohlins KA606 TTX RT rear shock is built for the Kawasaki ZX-10R platform, aimed at riders chasing predictable chassis behaviour and consistent damping across a wide range of conditions. It uses a pressurised damping system to help maintain stability when the shock is working hard. Adjustment circuits are separated to support precise changes without unwanted overlap.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, the TTX RT family focuses on damping consistency and clear feedback to the rider. The design is intended to keep the rear tyre working with the track surface, especially when loads change quickly through braking and acceleration.

Who this shock is for

  • Kawasaki ZX-10R riders wanting a dedicated rear shock upgrade for track days and performance road use
  • Owners looking for improved traction feel and stability from the rear end
  • Riders who value a tunable setup with independent damping adjustments

Shock design & features

This is an oil/gas separated, pressurised rear shock designed to reduce fade and keep damping consistent over longer sessions. The architecture separates the compression and rebound circuits, supporting repeatable tuning changes and stable performance as conditions and pace vary.

Tuning controls

The KA606 provides external rebound damping adjustment and compression damping adjustment. Spring preload adjustment is also provided to set ride height support and balance to suit the rider and intended use.

Before you install

  • Confirm fitment for your exact ZX-10R model and year before installation
  • Record your current settings so you can compare changes after fitting
  • After installation, set sag and then fine-tune rebound and compression to match tyres, pace and surface conditions

Serviceability/lifecycle

As a performance shock, periodic servicing helps maintain damping consistency and seal life. Regular inspection and scheduled oil and seal replacement are recommended, particularly if the bike sees frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA606
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 338.0 +4/-2
Spring Rate Standard 90.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 67.0
Product Family TTX RT
Fitted Spring 21040-29

More From This Category