The Ohlins STX 36 front shock pair for the Lambretta X300 is built around the same damping principles used across Ohlins road and race programs, focused on stable chassis control and clear feedback. This set is designed for front twin applications where consistent damping and controlled movement matter most. It uses a gas-pressurised, oil/gas separated architecture to help maintain damping consistency during repeated inputs.

Ohlins | Made to race, perfected to ride

Ohlins develops suspension with an engineering-first approach: controlled oil flow, stable pressure management and predictable damping behaviour. The STX 36 scooter platform is intended to deliver a composed front end with improved feel under braking and direction changes.

Who this shock is for

  • Lambretta X300 riders wanting a more controlled, confidence-inspiring front end
  • Owners upgrading from standard front units for better feedback over varied road surfaces
  • Riders who value precise damping behaviour rather than simply a firmer ride

Shock design & features

  • STX 36 scooter shock design
  • Gas-pressurised, oil/gas separated system to support consistent damping
  • Front twin configuration supplied as a pair
  • Note: the RH damper has no shims stack (as supplied)

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • Confirm front fitment for Lambretta X300 and twin-front mounting arrangement
  • Verify supplied springs and any notes applying to the RH unit before installation
  • After installation, set sag and then fine-tune rebound and compression to suit load and riding conditions

Serviceability/lifecycle

Ohlins shocks are designed to be serviced, with oil and wear components replaceable during scheduled maintenance. Regular servicing helps keep damping consistent and preserves internal components over time.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU LA329
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front twin
Shock Length Eye to Eye (mm) 300.5
Spring Rate Standard 7.0 - 18.0 N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 70.5
Product Family STX 36 Scooter
Notes RH damper has no shims stack
Fitted Spring 60240-41
Rec. Ohlins Oil 01309-

More From This Category