The Ohlins STX 36 scooter shock for the front of the Vespa Sprint 125 is built to give more controlled damping and better front-end feel in everyday riding. It’s designed to improve stability and confidence when the load shifts forward, such as during braking and quick direction changes. As with all suspension, correct setup is key to getting the best ride quality and control.

Ohlins | Made to race, perfected to ride

Ohlins develops its road-going suspension using the same engineering approach that underpins its racing programs. The aim is consistent damping performance, predictable chassis behaviour and a broader tuning window for different rider weights and riding conditions.

Who this shock is for

Suited to Vespa riders who want a more planted and composed front end than a basic OE-style unit. It’s a practical choice for commuting, urban riding and spirited weekend use where braking stability and steering accuracy matter.

Shock design & features

This is a gas-pressurised, oil/gas separated shock design to help maintain damping consistency as temperatures and workload increase. The STX 36 architecture focuses on controlled oil flow and stable damping behaviour, supporting improved traction and stability at the front wheel.

Tuning controls

Provides external damping adjustment so you can tune feel and response to suit your tyres, roads and riding style. Adjustability allows you to balance comfort against control and keep the front end settled when the pace increases.

Before you install

  • Confirm application and fitment for Vespa Sprint 125 front position before installation.
  • Set sag and damping in small steps after fitting, then re-check after a few rides.
  • If any existing bushings or mounting hardware are worn, replace them to avoid play and noise.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to restore performance over time. Regular maintenance helps keep damping consistent and extends component life, especially when the scooter is used frequently or in harsh conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI101
Model # S36P
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front
Shock Length Eye to Eye (mm) 263.0
Spring Rate Standard 13.0 - 34.2 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 72.0
Product Family STX 36 Scooter
Notes Front
Fitted Spring 60001-51
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category