The Ohlins PI301 STX 36 Street Shock Front is a front suspension upgrade for Vespa LX 125 and S125 models, aimed at improving control and consistency on the road. Built around Ohlins road-focused STX architecture, it is designed to deliver more stable damping behaviour during braking and cornering. The unit uses a gas-pressurised monotube design to help maintain damping performance over varying conditions.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on predictable damping response and repeatable handling. This STX 36 Street front shock is intended to provide clearer feedback at the front end, supporting confident steering and stability during everyday street riding.

Who this shock is for

  • Riders of Vespa LX 125 and S125 wanting improved front-end stability and feel
  • Owners looking for more controlled suspension response during braking and cornering
  • Street-focused riders who want a tunable front shock from a recognised suspension manufacturer

Shock design & features

  • STX 36 monotube construction
  • Gas-pressurised internal design for consistent damping behaviour
  • Valving developed for road use

Tuning controls

This front shock provides external damping adjustments for both compression and rebound, allowing you to tailor the response to rider preference and conditions.

Before you install

  • Confirm fitment for Vespa LX 125 and S125 and the correct front mounting position
  • Inspect related front-end components (bushes, mounts and fasteners) before installation
  • After installation, set sag and then fine-tune compression and rebound to suit your riding

Serviceability/lifecycle

As an Ohlins unit, the PI301 is designed to be maintained. Periodic servicing helps keep damping performance consistent over time, especially if the scooter is used frequently or in harsher conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI301
Model # S36P
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front single
Shock Length Eye to Eye (mm) 247.5
Spring Rate Standard 13.2 - 20.4 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 74.5
Product Family STX 36
Fitted Spring 60001-52

More From This Category