The Ohlins STX 36 rear shock for Vespa Sprint 150 is built to improve damping control and chassis stability in real-world scooter riding. Its design uses separated oil and gas to help maintain consistent performance as conditions change. This unit is intended as a direct-fit rear replacement with rider-adjustable damping.

Ohlins | Made to race, perfected to ride

Ohlins scooter suspension draws on the same engineering approach used across the brand’s performance ranges: controlled damping, stable behaviour and repeatable tuning. The focus is predictable feel and better support through braking, cornering and acceleration.

Who this shock is for

  • Vespa Sprint 150 riders wanting a more controlled rear end over bumps and surface changes
  • Riders who value tunability for comfort versus handling balance
  • Owners looking for a quality rear shock with serviceable construction

Shock design & features

This is an STX 36 rear scooter shock using a separated oil/gas layout (not an emulsion design) to support consistent damping behaviour. The architecture is aimed at maintaining stability and traction during everyday riding, including heavy braking and cornering loads.

Tuning controls

This shock provides spring preload adjustment and adjustable rebound damping, plus adjustable compression damping. These controls allow you to fine-tune support, comfort and response to suit rider weight, load and preferred ride feel.

Before you install

  • Confirm fitment for Vespa Sprint 150 and rear mounting position
  • Check the supplied/fitted spring and general condition of mounting hardware during installation
  • After installation, set sag and then use rebound and compression adjustments to dial in control and comfort

Serviceability/lifecycle

Ohlins shocks are designed to be serviced to restore performance as oil and wear parts age. Periodic servicing helps maintain damping consistency and protects long-term ride quality.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI502
Model # S36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear
Shock Length Eye to Eye (mm) 389.5
Spring Rate Standard 19.8 - 28.2N/mm Progressive
Type Code S36PR1C1
Stroke Metal to Metal (mm) 86.5
Product Family STX 36 Scooter
Fitted Spring 60480-14
Rec. Ohlins Oil 01309-

More From This Category