The Ohlins STX 36 rear scooter shock for the Honda Forza 300 is built to improve rear-end control and ride quality with a purpose-designed monotube damper. It uses a gas-pressurised, oil/gas separated layout to maintain consistent damping across changing road and temperature conditions. Adjustment is provided for rebound damping to help you tailor stability and comfort to your load and riding style.

Ohlins | Made to race, perfected to ride

Ohlins suspension development is grounded in repeatable damping control and predictable chassis behaviour. The STX 36 scooter range applies this approach in a compact rear shock format suited to daily commuting and higher-speed open-road riding.

Who this shock is for

  • Forza 300 riders chasing more controlled damping than a standard rear unit
  • Commuters who want improved support and stability over rough urban surfaces
  • Riders carrying a passenger or luggage who need a tuneable rear shock

Shock design & features

  • STX 36 monotube shock architecture designed for scooter rear fitment
  • Gas-pressurised damper with oil/gas separation to help reduce fade
  • Matched spring fitted from the factory for the intended application

Tuning controls

  • Rebound damping adjustment to fine-tune rear wheel control and chassis settling

Before you install

  • Confirm the shock is listed for Honda Forza 300 rear mono fitment
  • After installation, set sag and then use rebound adjustment to balance comfort and stability
  • Recheck mounting torque and clearances after the first few rides

Serviceability/lifecycle

As a performance shock, periodic servicing helps maintain damping consistency and seal life. Service intervals vary with use and conditions, but routine maintenance is recommended for long-term performance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO430
Model # S36PR1
Barcode # HO430
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 400.0
Spring Rate Standard 10.0 - 14.0 N/mm Progressive
Type Code S36PR1
Stroke Metal to Metal (mm) 115.0
Product Family STX 36 Scooter
Fitted Spring 60480-01
Spring Colour Yellow

More From This Category