The Ohlins PI921 STX 36 front scooter shock is built for the Vespa GTV 300 rider who wants more consistent damping control and clearer chassis feedback. It uses a gas-pressurised design to help maintain damping stability as conditions change. Supplied with mounting screws for installation.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, this front unit targets improved stability and traction during everyday riding as well as harder braking and faster cornering. The intent is predictable support and better feel at the front end.

Who this shock is for

  • Vespa GTV 300 owners upgrading the front suspension for sharper control
  • Riders who want better stability under braking and more confidence through corners
  • Anyone chasing more consistent damping performance from a quality aftermarket unit

Shock design & features

  • Gas-pressurised shock design to support consistent damping performance
  • STX 36 Scooter shock platform
  • Supplied with mounting screws as noted in the box contents

Tuning controls

This unit provides damping adjustment for both compression and rebound, using separate circuits to fine-tune how the front suspension responds to load changes, braking and cornering.

Before you install

  • Confirm fitment for Vespa GTV 300 and front mounting position before installation
  • Mounting screws 01046-21 (2x) are supplied in the box
  • Ohlins recommended oil is listed as 01309-

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU PI921
Model # S36P
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front single
Shock Length Eye to Eye (mm) 273.0
Spring Rate Standard 13.0 - 34.2 N/mm Progressive
Type Code S36P
Stroke Metal to Metal (mm) 82.0
Product Family STX 36 Scooter
Notes Mounting screws 01046-21 (2x) supplied in box.
Fitted Spring 60001-51
Rec. Ohlins Oil 01309-

More From This Category