The Ohlins RE912 STX 36 twin shock rear suspension is built for Royal Enfield Continental GT 650 and Interceptor 650 riders who want clearer feedback and more controlled chassis behaviour. Based on Ohlins twin-shock architecture, it’s designed to maintain consistent damping across varied road conditions. This unit uses a gas-pressurised, oil/gas separated design to help stabilise damping under sustained use.

Ohlins | Made to race, perfected to ride

Ohlins road-focused suspension is engineered around predictable damping control and repeatable adjustability. The RE912 follows that approach with a robust twin-shock layout intended to improve composure without making the bike feel harsh.

Who this shock is for

  • Riders upgrading from standard twin shocks for better control and confidence on the road
  • Owners who ride briskly on mixed surfaces and want more stability from the rear
  • Riders who value tunability for load changes such as luggage or different riding conditions

Shock design & features

  • STX 36 twin-shock configuration for rear fitment
  • Gas-pressurised, oil/gas separated damping layout
  • Designed to deliver consistent rear-wheel contact and controlled chassis movement

Tuning controls

  • Rebound damping adjustment
  • Length adjustment

Before you install

  • Confirm correct fitment for your Royal Enfield Continental GT 650 or Interceptor 650 before installation
  • After fitting, set sag and then fine-tune rebound to match your load and road conditions
  • Inspect mounting hardware and alignment during installation to avoid binding

Serviceability/lifecycle

Ohlins shocks are serviceable and intended to be maintained to keep damping performance consistent over time. Periodic inspection and servicing helps preserve seal condition and oil performance, especially if the bike sees frequent wet or dusty riding.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU RE912
Model # S36ER1L
Barcode # RE912
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.0 +8/-2
Spring Rate Standard 20.0 - 28.0 N/mm Progressive
Type Code S36ER1L
Stroke Metal to Metal (mm) 91.0
Product Family STX 36 Twin
Fitted Spring 60480-04
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category