The Ohlins NC416 STX 36 twin rear shock package is built for the Norton Commando where predictable damping and consistent control matter. It uses an oil/gas separated damping design to maintain stable performance as conditions change. The result is a rear suspension feel that stays composed and communicative across a wide range of road riding.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension know-how, this STX 36 twin setup focuses on controlled movement and clear feedback at the rear wheel. It is intended to support confident cornering and braking behaviour without making the bike feel harsh.

Who this shock is for

  • Norton Commando riders chasing a more controlled, modern rear suspension feel
  • Owners who want adjustability for different roads, loads, and riding styles
  • Riders looking to refresh or replace ageing twin shocks with a serviceable performance unit

Shock design & features

  • STX 36 twin rear shock architecture for classic twin-shock applications
  • Oil/gas separated damping design to help maintain consistency during use
  • Supplied with fitted springs as specified for this unit

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Adjustable length to fine-tune chassis attitude

Before you install

  • Confirm fitment and clearance on your Norton Commando, including hardware and mounting condition
  • Set sag and damping from a sensible baseline, then adjust one change at a time
  • Inspect linkages/bushes and fasteners so the shocks can work as intended

Serviceability/lifecycle

Ohlins shocks are designed to be maintained. Periodic servicing helps preserve damping consistency and keeps seals, oil, and wear items in good condition over the long term.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU NC416
Model # S36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 380.0 +8/-2
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Type Code S36PR1C1LB
Stroke Metal to Metal (mm) 96.0
Product Family STX 36 Twin
Fitted Spring 00480-02

More From This Category