The Ohlins SH1984 TTX Flow rear shock is built for Sherco enduro models that need consistent damping control and predictable chassis behaviour in varied terrain. It uses a gas-pressurised design to help maintain stable performance as conditions and ride intensity change. This unit is supplied without a spring, allowing the spring rate to be selected to suit rider weight and intended use.

Ohlins | Made to race, perfected to ride

TTX Flow technology is developed from Ohlins racing suspension, then refined for real-world enduro use. The focus is on maintaining traction and stability through braking bumps, accelerations and changing grip levels.

Shock design & features

  • TTX Flow architecture aimed at consistent damping behaviour across a wide range of conditions
  • Gas-pressurised construction to support stable performance over longer rides
  • Designed as a rear mono shock application for Sherco enduro fitments listed

Tuning controls

This shock provides external damping adjustments for both compression and rebound, allowing the feel to be tailored for terrain, pace and rider preference without internal revalving.

Base setup (factory preset)

The shock is delivered with an Ohlins baseline setting intended as a starting point. Fine-tuning compression and rebound is typically done after selecting the correct spring and confirming sag for your bike and load.

Before you install

  • No spring is supplied; select a compatible spring series as noted for this unit
  • Confirm fitment across your exact Sherco model and year within the listed range before installation
  • Use the recommended Ohlins suspension oil as specified for servicing

Serviceability/lifecycle

This Ohlins shock is fully serviceable and designed to be maintained. Regular servicing with the correct fluids and parts helps preserve damping consistency and seal life, especially in enduro conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SH1984
Model # T46PR1C1W
Barcode # SH1984
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category