The Ohlins STX 46 Supersport rear shock for the Yoshimura Tornado S1 is built around a modern monotube architecture aimed at consistent damping and clear feedback. It is designed to support precise chassis control when riding at higher pace, where repeatability matters. This unit uses a separated oil/gas design to help maintain stable damping behaviour over longer sessions.

Ohlins | Made to race, perfected to ride

Developed from Ohlins road racing suspension experience, the STX 46 Supersport family focuses on controlled damping, traction and predictable support. The design intent is practical tuneability with reliable performance rather than a one-size-fits-all feel.

Who this shock is for

Suited to Yoshimura Tornado S1 riders who want a higher level of damping control for track use, fast road riding, or tyres with more grip than stock. It’s also a good match if you want a more structured platform under braking and acceleration, with the ability to fine-tune the response.

Shock design & features

This is a rear mono shock from the Ohlins STX 46 Supersport range, using a monotube layout with oil and gas separation. The construction is aimed at consistent damping and improved response to rapid changes in load, supporting stability through corner entry and drive on exit.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to balance support, grip and chassis attitude. It also includes a length adjuster to help fine-tune rear ride height and geometry to suit your setup and tyres.

Before you install

  • Confirm clearance around linkages, exhaust routing and bodywork before final tightening.
  • Check sag and spring preload after installation to suit rider weight and intended use.
  • Make adjustments methodically, one change at a time, and note your settings as you go.

Serviceability/lifecycle

Like all performance shocks, this unit is serviceable and benefits from periodic maintenance to keep damping consistent. Service intervals depend on usage intensity and conditions, particularly for regular track work.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU147
Model # S46PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 328.0 +6/0
Spring Rate Standard 95.0 N/mm
Type Code S46PR1C1LS
Stroke Metal to Metal (mm) 74.0
Product Family STX 46 Supersport
Fitted Spring 01091-31
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category