The Ohlins TTX 44 rear shock for Suzuki RM-Z 250 is built around Ohlins’ twin-tube damping concept to keep damping behaviour consistent across changing track conditions. It’s a gas-pressurised, oil/gas separated design intended for controlled response and repeatable feel. This unit is supplied without a spring, allowing the correct spring rate to be selected separately for rider weight and use.

Ohlins | Made to race, perfected to ride

TTX architecture separates and balances damping flow for predictable control through the stroke. The focus is on stability, traction and clear feedback rather than a vague “soft” or “stiff” feel.

Shock design & features

  • TTX 44 twin-tube rear shock layout
  • Gas-pressurised, oil/gas separated damping system
  • Rear mono fitment for Suzuki RM-Z 250 applications
  • No spring supplied; spring selected and purchased separately as noted for the required spring series

Tuning controls

This shock provides external adjustability for compression and rebound damping, allowing changes to chassis attitude, traction and bump control to be made without internal modifications.

Base setup (factory preset)

The shock is delivered with an Ohlins base setting to suit the intended application, with fine-tuning handled via the external compression and rebound adjusters once the correct spring is fitted.

Before you install

  • Confirm the correct spring series and rate is selected, as no spring is included with this unit
  • Follow standard workshop practice for installation and sag setting
  • Use the recommended Ohlins shock oil where servicing is required

Serviceability/lifecycle

Like all performance dampers, periodic servicing is part of ownership to keep damping consistent. The oil and wear components are replaceable during routine maintenance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU1693
Model # T44PR1C2W
Barcode # SU1693
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T44PR1C2W
Product Family TTX 44
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category