Ohlins suspension unit for the Kawasaki D-Tracker (PCS). Built around Ohlins’ established approach to controlled damping and consistent feel, it’s intended as a direct-fit replacement where applicable. Use this listing to confirm vehicle compatibility before purchase.

Ohlins | Made to race, perfected to ride

Ohlins units are developed with a focus on predictable chassis behaviour and repeatable adjustment. This model is supplied as an Ohlins shock absorber application for the D-Tracker platform.

Who this shock is for

Suitable for riders looking to refresh worn suspension or move to a higher-quality shock for more control and feedback on the street or light off-road use. Also relevant if you need a serviceable shock with long-term support.

Shock design & features

The input data provided does not include the internal architecture details, so the shock type (emulsion or oil/gas separated) cannot be confirmed here. Fitment is indicated for Kawasaki D-Tracker with PCS; confirm exact model/year match before ordering.

Tuning controls

Adjustment features are not specified in the provided product row. If you need confirmation of which tuning controls are included (for example, rebound, compression, or preload adjustment), check the application notes or the manufacturer documentation for this exact part number.

Before you install

  • Confirm your exact model and year, and any relevant sub-model notes for PCS.
  • Inspect linkage bearings and mounting hardware during installation to ensure the shock can work correctly.
  • After installation, set sag and verify clearances through full suspension travel.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA462
Barcode # KA462
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category