The Ohlins YA010 is a rear suspension unit for the Yamaha Cygnus 6, built around the STX 36 Twin architecture for consistent damping control and rider feedback. It is an oil/gas separated design to help maintain stable performance over varied road conditions. This unit is intended for riders who want a more controlled, tunable rear end without changing the character of the bike.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping quality, consistency and serviceability. The aim is predictable grip and chassis control, with adjustment range that lets you match the bike to your load and roads.

Who this shock is for

  • Yamaha Cygnus 6 riders looking for improved control and feel from the rear suspension
  • Commuters and weekend riders who want a more composed ride over changing surfaces
  • Riders who value tunability to suit different loads and riding conditions

Shock design & features

  • STX 36 Twin rear shock design
  • Oil/gas separated construction for consistent damping behaviour
  • Designed as a rear-fitment unit for the Yamaha Cygnus 6
  • Supplied with a fitted spring (as listed in the product data)

Tuning controls

  • Rebound damping adjustment
  • Spring preload adjustment

Before you install

  • Confirm model and fitment for Yamaha Cygnus 6 prior to installation
  • Set sag and preload to suit rider weight and typical load
  • After installation, recheck fasteners and clearances through full suspension movement

Serviceability/lifecycle

This Ohlins unit is designed to be serviced to maintain damping performance over time. Periodic inspection and servicing helps keep oil condition, seals and damping behaviour consistent, especially with regular use in wet or dusty conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA010
Model # S36PR1
Barcode # YA010
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 314.5
Spring Rate Standard 14.0 - 21.0 N/mm Progressive
Type Code S36PR1
Stroke Metal to Metal (mm) 84.5
Product Family STX 36 Twin
Fitted Spring 60240-03
Spring Colour Yellow

More From This Category