The Tractive X-TREME shock for the Husqvarna 701 ENDURO is a closed, pressurised shock absorber built around a sealed cartridge design for consistent damping. It uses oil and gas separation to help maintain stable feel as conditions change. This unit is configured with triple adjustment, giving you control over key damping behaviours.

Design & features

  • Closed, pressurised shock absorber with a sealed cartridge architecture
  • Oil/gas separated design to support consistent damping performance
  • Triple-adjustable damping configuration
  • Supplied as a sprung shock (spring included)

Tuning Controls

  • Triple adjustment for damping, allowing separate control of rebound and compression circuits

Base Setup (factory preset)

Delivered with a factory baseline valving and settings intended as a starting point. Final setup will depend on rider mass, load, and intended terrain, and should be confirmed during installation and initial shakedown rides.

Who is this for?

  • Riders who want broader tuning range via triple damping adjustment
  • 701 ENDURO owners riding mixed conditions who value consistent damping from a pressurised, separated-gas design

Before You Install

  • Confirm fitment for your exact Husqvarna 701 ENDURO variant and year
  • Set sag and verify spring rate suitability for your typical riding load
  • Record your initial adjuster positions before making changes so you can return to a known baseline

Serviceability/Lifecycle

As a sealed, pressurised shock with oil/gas separation, periodic servicing helps maintain performance over time. Service intervals depend on usage and conditions; off-road use typically increases service frequency.

Teknik Motorsport Pty Ltd Warranty terms for TracTive products.

This TracTive product has been assembled with the utmost care and tested according to ISO9001:2015 Quality system. In the unlikely event that the product does not fulfill your expectations because of faulty materials or manufacturing errors, please contact us through your dealer.

Teknik Motorsport Pty Ltd warrants that if, within 24 months of the date of sale the product is found to be defective as a result of manufacturing errors or faulty components, the product will be repaired free of charge by us, or by a TracTive approved repairer at our discretion.

Warranty covers the direct service material cost, service labour cost ($80/hr AUD) and shipping costs of the service partner. Other costs will be regarded on a case by case basis by Teknik Motorsport and TracTive.

 When a claim is made under the warranty, the following conditions have to be met:

  • You must have read the instructions carefully before mounting the product in the vehicle or adjusting the product.
  • The product has to be installed and adjusted as described in the instructions
  • The product must have been maintained and serviced in accordance with the recommendations in the manual. If not described in the manual, the recommended service intervals for regular street use: every 30.000 km or max 2 years, whichever is earlier.
  • Warranty shall apply only when TracTive original parts, procedures and tools have been used to service and/or repair, and if service and repair is performed by designated TracTive partners.
  • The product may not have been neglected, improperly used, altered or subjected to excessive loads. Excluded from warranty are normal wear, damage and rust.
  • A sales receipt or other proof of purchase originally eminating from Teknik Motorsport Pty Ltd. No warranty will be given on TracTive or Touratech products not purchased from or through Teknik Motorsport pty ltd.
  • Excluded from warranty are in particular products which are used in vehicles that are intended or suitable for taking part in sporting events, or have actually been used this way.
  • Recommended service interval for Motorsport applications: every season, or every 50 hours, every 10.000km or after any perceived loss in performance.
SKU 46KT19-T9537-TR-01
Model # 46KT19-T9537-TR-01
Barcode # 46KT19T9537TR01
Brand TracTive Suspension
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.400m
Unit Of Measure ea
Type X-TREME
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear
Damping Adjustment Type Rebound & Compression High + Low Speed
Shock Options - Hydraulic Preload Adjuster Hydraulic with knob
Seat Height Change (mm) Raised +25
Shock Length Eye to Eye (mm) 404.0
Spring Rate Standard 75 N/mm
Type Code X-TREME
Stroke Metal to Metal (mm) 106.0
Notes PDSII anti-bottoming
Fitted Spring 75-205

You May Also Like

Related products

More From This Category