The Ohlins BA1784 TTX Flow rear shock is a dedicated replacement unit for Beta RR two-stroke and four-stroke enduro models, including Racing variants. Built around Ohlins’ race-derived damping architecture, it is intended to deliver consistent control and traction across changing terrain. This unit is supplied without a spring, allowing spring selection to match rider weight and use.

Ohlins | Made to race, perfected to ride

TTX Flow technology is developed from competition suspension programs and packaged for enduro use where grip, stability and repeatable damping matter. The design focus is on maintaining controlled wheel movement and predictable chassis behaviour as conditions vary.

Who this shock is for

  • Beta RR riders wanting higher damping control and feedback from the rear suspension
  • Riders who tune their setup for different tracks, terrain and pace
  • Owners who want to select an appropriate spring separately rather than using a one-size option

Shock design & features

  • Oil and gas are separated for stable damping performance under sustained use
  • TTX Flow architecture designed for consistent response through the stroke
  • Rear mono fitment for the listed Beta RR models and Racing variants

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • No spring supplied; spring is sold separately (refer to the noted spring series for selection)
  • Confirm fitment for your exact model and year within the Beta RR range listed
  • Use the recommended Ohlins shock oil specified for this unit during service

Serviceability/lifecycle

This shock is designed to be serviced and re-valved as required, supporting long-term use with routine maintenance. Regular inspection and oil service help keep damping consistent and protect internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BA1784
Model # T46PR1C1W
Barcode # BA1784
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 490.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category