The Ohlins BA2184 TTX Flow DV is a rear mono shock for Beta RR two-stroke and four-stroke models. Built around the TTX Flow DV platform, it is intended to deliver controlled damping and consistent feel across changing track and trail conditions. This unit is supplied without a spring, allowing spring selection to suit rider and bike setup.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, stability and serviceability. The TTX Flow DV family is aimed at riders who want a broad, usable tuning range with clear adjustment feedback.

Who this shock is for

  • Beta RR riders wanting a quality replacement or performance-focused rear shock
  • Enduro and off-road riders who need consistent damping feel during longer rides
  • Owners who prefer a shock with separate tuning control over compression and rebound

Shock design & features

  • TTX Flow DV rear mono shock architecture
  • Oil and gas separated, gas-pressurised design to support damping consistency
  • Designed for Beta RR fitment across the listed 2T and 4T models
  • No spring supplied; spring is selected and purchased separately

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm spring selection before fitting, as this unit is supplied without a spring
  • Follow Beta and Ohlins workshop procedures for installation and sag setup
  • If your bike requires a specific spring series, refer to the notes supplied with the product listing

Serviceability/lifecycle

This shock is designed to be serviced and revalved as required. Routine servicing helps maintain damping consistency and seal life, particularly for frequent off-road use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BA2184
Model # T46PR1C2W
Barcode # BA2184
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Product Family TTX Flow DV
Notes 06310- & 06451- spring series *Replaced by DMX 0305*
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01304-

More From This Category