The Ohlins TTX Flow rear shock for Beta RR models is built around stable damping behaviour and clear feedback when conditions change. It suits riders who want consistent traction and predictable chassis response across varied enduro and motocross terrain. This unit is supplied without a spring, allowing spring selection to match rider weight and use.

Ohlins | Made to race, perfected to ride

TTX Flow technology is developed from Ohlins competition damping concepts and refined for high control and repeatable feel. The design focuses on maintaining damping consistency as the shock works hard over long, rough stages.

Who this shock is for

  • Beta RR riders chasing a more controlled rear end under braking bumps, square edges and acceleration chop
  • Riders who want a broader, more useable adjustment range for different terrain and pace
  • Anyone setting the bike up properly with a chosen spring (spring sold separately)

Shock design & features

  • Oil and gas separated design to help maintain damping consistency during sustained use
  • TTX Flow architecture aimed at improved sensitivity and traction over changing surfaces
  • Intended for rear mono-shock fitment on compatible Beta RR 2T and 4T models listed

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • Confirm spring selection and fitment before installation, as no spring is supplied
  • Set sag and baseline clicker positions after fitting, then fine-tune rebound and compression to suit terrain
  • Check clearance and hose/reservoir routing (where applicable) and re-torque mounting hardware after initial ride

Serviceability/lifecycle

This Ohlins unit is fully serviceable. Regular oil and seal maintenance helps keep damping consistent and protects internal components, particularly when used in muddy, dusty or high-hour conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BA1884
Model # T46PR1C1W
Barcode # BA1884
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 490.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Product Family TTX Flow
Notes 06310- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category