The Ohlins TTX Flow rear shock for the Yamaha YZ 450F is built around a race-derived damping architecture aimed at delivering consistent control across changing track conditions. It is a gas-pressurised, oil/gas separated design to help maintain damping stability during long motos. Supplied without a spring, it is intended to be paired with an appropriate-rate spring to suit rider weight and use.

Ohlins | Made to race, perfected to ride

TTX Flow technology focuses on stable damping behaviour and clear feedback at the rear wheel. The design is intended to support traction and chassis balance when the pace increases and the terrain gets rough.

Who this shock is for

  • YZ 450F riders wanting a higher level of rear-end control and tunability than a basic replacement shock
  • Motocross and off-road riders who tune suspension to match track conditions, tyres, and riding style
  • Riders who already have (or plan to select) a suitable spring rate, as no spring is supplied

Shock design & features

  • TTX Flow damping layout for consistent behaviour through the stroke
  • Gas-pressurised, oil/gas separated construction to help resist fade
  • Valving developed from Ohlins racing experience for controlled traction and stability

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • No spring supplied; spring is sold separately and must be selected to suit the bike and rider (see included notes for compatible spring series)
  • Have sag and damping set after installation to suit your weight, pace, and terrain

Serviceability/lifecycle

This is a fully serviceable performance shock designed to be maintained. Regular servicing helps keep damping consistent and protects internal components when used in harsh MX/enduro conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA2094
Model # T46PR1C1W
Barcode # YA2094
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 460.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C1W
Stroke Metal to Metal (mm) 138.0
Product Family TTX Flow
Notes 06310- and 06451-series spring
Fitted Spring Sold separately, see notes.

More From This Category