The Ohlins DMX0003 is a TTX 30 rear shock developed for KTM 65 SX fitment. Built around Ohlins’ twin-tube damping architecture, it’s designed to deliver consistent control through changing track conditions. This unit is supplied without a spring, allowing spring selection to suit rider weight and use.

Ohlins | Made to race, perfected to ride

TTX 30 is Ohlins’ twin-tube concept, designed to keep damping stable and predictable over a wide range of riding conditions. The focus is repeatable performance and clear adjustment response for riders and tuners.

Shock design & features

  • Twin-tube TTX 30 architecture for consistent damping behaviour
  • Oil/gas separated design to support stable damping over longer motos
  • Rear shock configuration intended as a direct-fit replacement for the listed model
  • Supplied with no spring; spring is sold separately (see notes)

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • Spring preload adjustment (spring dependent)

Before you install

  • Confirm correct spring series and select an appropriate spring, as no spring is supplied
  • Inspect linkage and bearings and service if required before fitting a new shock
  • Set sag and then fine-tune rebound and compression to suit track conditions and rider preference

Serviceability/lifecycle

This Ohlins shock is a fully serviceable performance unit. Regular servicing helps maintain damping consistency, seal condition and overall performance, particularly in motocross environments where contamination and heat cycles are common.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0003
Model # T30PR1C1W
Barcode # DMX0003
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Shock Length Eye to Eye (mm) 328.0
Spring Rate No Spring/s Supplied
Type Code T30PR1C1W
Stroke Metal to Metal (mm) 90.0
Product Family TTX 30
Notes 00181- spring series
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category