The Ohlins DMX0215 is a rear shock absorber from the TTX Flow DV range, built for KTM 450 SX-F fitment where consistent damping control and clear chassis feedback matter. It is designed as a performance-focused replacement unit, with external adjustments to tailor behaviour to rider preference and track conditions. This listing is for the shock unit; spring selection is supplied separately as noted.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a strong focus on damping consistency, traction and controllable feel. The TTX Flow DV architecture is aimed at maintaining predictable behaviour across changing conditions, helping you keep the bike balanced under load.

Who this shock is for

Suited to riders who want a more tuneable rear end for motocross and enduro-style use, and who value stable drive and feedback through corners, braking zones and acceleration bumps. It is also a practical choice if you want an Ohlins unit that can be set up to match different tracks and rider preferences.

Shock design & features

This is a gas-pressurised shock with oil and gas separated for consistent damping behaviour. The TTX Flow DV design uses dedicated damping circuits to support controlled movement through the stroke and to help maintain traction when conditions get demanding.

Tuning controls

The DMX0215 provides external adjustment for compression and rebound damping, allowing you to fine-tune support, grip and recovery speed. This makes it easier to adapt the bike for different track layouts, surface conditions and riding style.

Before you install

  • No spring is supplied; spring choice is sold separately (refer to the notes in this listing for the recommended spring series).
  • This shock is listed as a replacement for an earlier Ohlins application (refer to notes).
  • Confirm correct fitment and any required preload adjuster parts as per the notes provided.

Serviceability/lifecycle

Like any high-performance shock, periodic servicing helps maintain damping consistency and seal condition. Use the recommended Ohlins shock oil listed for this unit when servicing.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DMX0215
Model # T46PR1C2W
Barcode # DMX0215
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 457.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Stroke Metal to Metal (mm) 137.0
Product Family TTX Flow DV
Notes 06310- series spring. Preload adjuster 15000-02 fits this shock. *Replaces DMX 0203*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

Related products

More From This Category

TracTive KTM 690 Enduro R Rear Shock X-TREME Special Order

TracTive KTM 690 Enduro R Rear Shock X-TREME

Rear | Lowered -25mm(SKU: 46KT08-T9105-TR)

$2,725.00

Custom build by TracTive Netherlands for every order. Usually 6-8 weeks depending on component availability